activate full view in Unigraphics NX 6

started on UGS NX 6 upwards there a special button to switch the display, from the display as usual (there is a toolbar, menu, selection, in addition to above, right, left and bottom sometimes) to display full view, the position of the toolbar move downward with ribbon system , classified by type of toolbar, these views simplify the design, but it takes practice to get used.
picture below is the view you normally see from Unigraphics NX1 up to Unigraphics  NX 5

 while the image below is a full picture view to NX 6 with toolbars and menus are grouped in a ribbon at the bottom

to change the look of a full view into plain view, and otherwise, you can use the buttons on the right above, (i red circle), a small button that will make you more comfortable to do presentations that require the display width

Posted in: full view,visualization